The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error





Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] New i50 speed display showing -- for speed
12-15-19, 05:00 PM (This post was last modified: 12-16-19 03:16 PM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] New i50 speed display showing -- for speed
I recently purchased new i50/i60 instruments. I decided to test each unit prior to de-installing the old instruments and installing the new and plugged each unit, one at a time, into the seatalk ng spur and attaching the transducers. The boat speed instrument showed -- as the speed, even as I spun the paddle wheel. So I have a couple of questions:

1. Do I need to spin the paddle wheel for a specified amount of time before the display starts to show speed, or will the instrument show speed immediately?
2. Is there something I need to do to commission the instrument before it can work effectively?
3. Is there a better way to test this unit before I install?

The depth and wind instruments worked fine when I test them. Thank you.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA11] New i50 speed display showing -- for speed - bwehmer - 12-15-19 05:00 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)