Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[LW] [LW11] Failure detection for autopilot Autohelm 6000
01-15-20, 04:34 AM
Post: #2
RE: [LW11] Failure detection for autopilot Autohelm 6000
Dear edouardleveau,

Thank you for your post.

Do a full 360' turn in standby and look at the heading data, does it run smoothly with no jumps or sticking. If it does not run smoothly this could indicate a source of deviation or the compass is sticking inside.

Is your rudder reference operating as expected, turn the rudder slowly to port and perform the same turning to starboard. Does the indicator display as expected? If not this could indicate a faulty rudder reference unit.

Complete the seatrial calibration, this can be found in the manual.

If you continue to experience issues with the pilot you can send it back to us for testing, however we do not have any spares to repair this pilot.

Where are you located?

Many Thanks
Louise
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [LW11] Failure detection for autopilot Autohelm 6000 - Louise - Raymarine - Moderator - 01-15-20 04:34 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)