Lack of detail with Navionics+ charts

[Chuck - Raymarine - Moderator]

Welcome to the Raymarine Forum Ben,

It is recommended that you update the software within your Raymarine MFDs with v17.45 or later a/c/e/eS/gS-Series MFD software. Commencing with version 17.45, the default Chart Selection setting for each Raymarine MFD, necessitating that the user select Navionics Nautical Charts within each Chart application page/pane in which it is desired that they be viewed. Commencing with v17.45, the Chart Selection dialog will additionally list detailed information for any chart card sensed by the system. Should the Chart Selection dialog not list this detailed information and the chart card be located within the same MFD's memory card reader, then there may be a problem with either the data which has been programmed onto the chart card or with the MFD's memory card reader. In the case of the latter, the memory card reader may be tested by successfully commanding that the MFD's screen image be captured to a microSD memory card. Should the MFD be unable do so, then it would indicate a fault with the MFD's memory card reader and it would correspondingly be recommended that the MFD be serviced by Raymarine’s Product Repair Center. Should the MFD's memory card reader slots both be operational, then chart card's contents should be updated again. Should the problem persist, then is it recommended that Navionics be contacted to test/correct any problem with your chart card.