[DG] [DG11] Temperature from Itc5 is not shown in Mfd
|
02-25-20, 06:44 AM
Post: #2
|
|||
|
|||
RE: [DG11] Temperature from Itc5 is not shown in Mfd
Hi JanneHson
Thankyou for your enquiry, There should be no issue with this as far as we know, a couple of things to check, Go into multiple Data Source selection in the AXIOM and select the DST as source of Speed, depth and Temperature - even if it is selected already, make sure that you RESELECT it again to be sure that the itc-5 that is the source for the data. The other alternative is to measure the resistance across the temperature thermocouple wires, 10k ohm is about 24 degrees Celcius. Regards Derek |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
[DG11] Temperature from Itc5 is not shown in Mfd - JanneHson - 02-22-20, 04:55 PM
RE: [DG11] Temperature from Itc5 is not shown in Mfd - Derek - Raymarine - Moderator - 02-25-20 06:44 AM
|
User(s) browsing this thread: 1 Guest(s)