[TG] [TG11] No pilot - P70, acu100, ev1

[Richie-mort]

I am still trying to figure this out so i can make a decision whether to replace faulty part or get rid of the whole lot, which would be hard to sell not knowing what is wrong basically rendering it worthless?

I have done more research and have now done the following:

I have checked the resistance of both terminators. Both 120ohms

I checked the network CanL CanH resistances (by removing a terminator and measuring) both ends were 120ohms which apparently is right.

If anyone can provide any further advice it would greatly be appreciated. (P70r is still showing no pilot, not seeing any other device etc).