MyBB Internal: One or more warnings occured. Please contact your administrator for assistance.
[CA11] AIS 700 antenna end removal


Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA11] AIS 700 antenna end removal
04-02-20, 02:02 PM (This post was last modified: 04-02-20 02:25 PM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] AIS 700 antenna end removal
In order to install my AIS700's GNSS antenna I will need to remove one end of the antenna's cable (ie: either cut and replace the plug end or open up the antenna and disconnect the wire as it is connected inside the antenna itself). I have an electronics background and would rather de-solder/re-solder the wires inside the antenna head if possible. My question is whether this method is wrought with potentiual problems or if it's easily done. BTW: I notice the screws in the plastic antenna head are tiny Bristol type ones.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA11] AIS 700 antenna end removal - sailorcanuck - 04-02-20 02:02 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)