Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Networking a95 to non-Raymarine A/P
06-12-17, 09:29 AM (This post was last modified: 06-12-17 09:29 AM by Chuck - Raymarine - Moderator.)
Post: #8
RE: Networking a95 to non-Raymarine A/P
cappy208,

The NMEA 0183 sentences listed below are supported by the a95 MFD. Should the Comnav 1420 AP support NMEA 0183 v2.1 or higher communications protocol (recommend consulting the autopilot's documentation or contacting the autopilot's manufacturer), then the MFD may be interfaced to the autopilot as follows:
- Connect the MFD's NMEA 0183 OUT+ lead (yellow) the third party autopilot course computer's NMEA 0183 IN+ lead/terminal
- Connect the MFD's NMEA 0183 OUT- lead (brown) the third party autopilot course computer's NMEA 0183 IN- lead/terminal

Should the autopilot transmit NMEA 0183 RSD (rudder angle) and HDG, HDM, or HDT (heading) sentences, then additionally:
- Connect the MFD's NMEA 0183 IN+ lead (white) the third party autopilot course computer's NMEA 0183 OUT+ lead/terminal
- Connect the MFD's NMEA 0183 IN- lead (green) the third party autopilot course computer's NMEA 0183 OUT- lead/terminal
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Networking a95 to non-Raymarine A/P - Chuck - Raymarine - Moderator - 06-12-17 09:29 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)