The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Instruments v / [DG] [DG11] i50 depth issues

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[DG] [DG11] i50 depth issues
04-30-20, 02:57 PM (This post was last modified: 04-30-20 03:12 PM by Chuck - Raymarine - Moderator.)
Post: #1
Sergel Offline
Junior Member
**
 		Posts: 1
Joined: Jan 2020
Reputation: 0
[DG11] i50 depth issues
I had a problem with my i60 not showing any relevant data. This was diagnosed to be due to a faulty iTC5. After exchanging the iTC5 the i60 now works fine, but the i50 depth does not; it only displays the three ---. Calibration functions etc on the i50 apparently work normally, and the depth sensor (and presumably the iTC5) works, because the depth is displayed correctly on the MFD. The STng also seems fine (the i60 is downstream of the i50). I have reloaded the firmware on the i50 and tried to reset to factory settings but without effect. Do you have suggestions for what to try?
Thank you,
Sergel
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[DG11] i50 depth issues - Sergel - 04-30-20 02:57 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication