The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error





Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[TG11]Autopilot cancels course
04-30-20, 06:09 PM (This post was last modified: 05-01-20 10:40 AM by Chris - Raymarine - Moderator.)
Post: #1
[TG11]Autopilot cancels course
Hi all,

Every now and again my axiom/autopilot says course finished when its not. Happens intermittently. Happens in both goto... and on a routed course.

All ray marine instruments Axioms x 2, Autopilot, Radar, CP570, HS5, and Seatalk(ng), are on an isolated power supply set at 13.8 volts. Very clean power. nothing else on the Seatalk network except a nmea Yacht devices isolated droper to droper interface to connect rest of boat NEMA2000 backbone. ETEC, Guages, ETC.

Not sure is its related but on power up, master home page screen options wont respond. I use slave axiom to go to change to guest profile then back to skipper and it comes alive again.

I have Navionics card in Master, no other sd cards,

Version v3.11.42

any ideas...

Cheers
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[TG11]Autopilot cancels course - Finatic2017 - 04-30-20 06:09 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)