The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error





Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CC11] reconnecting wires to M81188 rudder position sensor please
04-30-20, 11:33 PM (This post was last modified: 05-01-20 10:48 AM by Chris - Raymarine - Moderator.)
Post: #1
[CC11] reconnecting wires to M81188 rudder position sensor please
I became a co-owner on a tiller sailboat.
The drive and M81188 rudder position sensor were not attached to the mounting and bouncing around so the cable tore off the rudder position sensor. Inside is a Vishay “board” with schematic of a variable resistor and 3 terminals. I believe “blue” wire goes to #2 (center tap) and “red” and “green” go to #1 and #3 (ends). Which goes on which end?

I guess if I get it wrong I can reverse at the course computer but prefer to keep the current calibration.

Thanks!
Mark
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CC11] reconnecting wires to M81188 rudder position sensor please - mramsbey - 04-30-20 11:33 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)