The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Autopilots v / [TG] [TG11] Poor range with smartcontroller

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[TG] [TG11] Poor range with smartcontroller
05-10-20, 11:00 AM (This post was last modified: 05-13-20 02:01 AM by Tom - Raymarine - Moderator.)
Post: #1
joetomberlin Offline
Junior Member
**
 		Posts: 2
Joined: Aug 2019
Reputation: 0
[TG11] Poor range with smartcontroller
A few months ago I installed a new EV-100 Wheel Evolution Autopilot and with it a SmartController. Since the installation I have had problems getting the SmartController to stay connected to the base and finally started troubleshooting the issue.

If I hold the remote within a few inches of the base, it connects with full signal, 5 bars. If I move the remote to beyond 3 feet it drops the connection entirely. In the range between, I see no lowering of the signal level, it stays at 5 bars until it drops off completely.

At first I thought maybe the power connection was not solid an re-checked the wiring and all looked good. Inside the base on the connection block, I checked the voltage and it stayed a steady 12.7 volts while moving the remote in and out of the 3 ft range and the connect/disconnect events.

Is there anything else I can try, or is this likely a return for repair issue?
Joe T.
'06 Beneteau 343
Regina del Seni
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[TG11] Poor range with smartcontroller - joetomberlin - 05-10-20 11:00 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication