Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[DG] [DG11] St60 and itc5
05-13-20, 12:00 PM
Post: #2
RE: [DG11] St60 and itc5
Hi Joel,

Thanks for the enquiry,

best to rewind a bit, the compass sensor should always be connected to the autopilot course computer, the S2G need sthe compass direct connected to work correctly.

I am guessing from your diagram that the seatalk is powered as it the STng, so you need to cut the red core in the Yellow seatalk wire to the converter because you are powering the converter both through the SeaTalk and through the STng and this is not allowed under the NMEA2000 rules.

Cut the red core leaving just te tyellow and the screen connected between the SeaTalk part of the system and the Converter. the converter then will only take its power from the STng backbone.

Now check the status of the LEDs in the itc5, when the depth is pinging, the wind anemometer is spinning and the speed paddlewheel is spinning, you should see solid green leds next to the transducers plugged in to the itc-5.

Thanks
Derek
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[DG11] St60 and itc5 - jkar - 05-11-20, 01:45 PM
RE: [DG11] St60 and itc5 - Derek - Raymarine - Moderator - 05-13-20 12:00 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)