[TG] [TG11] Waypoint transfer from E Series to Axiom Pro

[Tom - Raymarine - Moderator]

Hello shawk,

The limit(s) are set by the relevant MFDs:

• E-series Classic (v5 software): 1,200 waypoints, 50 routes of 150 waypoints each, 10 tracks of 1,000 trackpoints each
• Axiom-series (LH3.11 software): 10,000 waypoints (200 waypoint groups), 150 routes of 250 waypoints each, 16 tracks of 10,000 trackpoints each
  

As far as the symbols go, that depends I suspect on the specific symbol and whether the E-Classic and LH3 both have a particular symbol in common. I would expect so, but haven't tested.

Finally, to expand on the FAQ: E-series Classic used a proprietary waypoint file format called Archive.fsh. More recent MFDs (since Lighthouse 2 v14 software) use the now-standard GPX format. There are various ways to convert between the two, but the easiest is using a bit of free PC software. The steps are:

1. On the E120, Data > Archive and transfer > Save to card > Waypoints > Save All / Routes > Save all / Tracks > Save all[i/] (you need to press [i]Save all individually for waypoints, routes and tracks, as each press of Save all only saves all of that type of data.) We generally recommend saving to a blank card, but the chart card will also work if you can't get hold of a blank card of a suitably small capacity (modern, high-capacity cards likely won't work in this old display.)
2. Remove the CompactFlash (CF) card that you have just saved your data to
3. Plug the CF card into a USB CF Reader (which you can buy from a computer, photographic or office-supplies shop)
4. Follow the rest of the step-by-step instructions here
5. Copy your new GPX file to a blank, 32Gb or smaller MicroSD card (again, via a USB card reader or a built-in SD slot in your computer)
6. Plug this MicroSD card into your new display and go to Home > My Data > Import/export > Import from card to load them in.
   

Regards,
Tom