[TG] [TG11] AIS data on SeaTalkNG Network
|
05-20-20, 11:53 PM
Post: #2
|
|||
|
|||
RE: [TG11] AIS data on SeaTalkNG Network
Hello Dave,
If you have a look at the [url=https://forum.raymarine.com/showthread.php?tid=1890]e95' NMEA2000 diagnostic page, do you see any messages where the Message column's first block of 8 characters all together (that is then followed by 8 pairs of characters separated by spaces) has, as the middle 4 characters, any of the following: Code: F80E If you see any of these, these are AIS messages and I would check to make sure that you have the AIS Layer enabled on your chart display. If you don't see any of those messages then I would see what diagnostics the Actisense or NoLand interfaces offer through their setup software. Or get an NMEA2000 AIS. If in doubt, save a log of your NMEA2000 data using the instructions on that page and post it back here. Regards, Tom Raymarine since 1999. Interests: Diagnosis of problems in sonar/fishfinders, NMEA2000, ethernet comms, autopilots, thermal cameras Location: Sydney, Australia. Please don't PM me asking for direct support, please ask a public question instead so that others can see the question and answer. Forum posts will always be answered before PM requests. |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
[TG11] AIS data on SeaTalkNG Network - daknecht - 05-19-20, 07:42 AM
RE: [TG11] AIS data on SeaTalkNG Network - Tom - Raymarine - Moderator - 05-20-20 11:53 PM
|
User(s) browsing this thread: 1 Guest(s)