Raymarine forum / Raymarine Forums / General Discussions v / [TG] [TG11] 3.11.42 update and no heading error

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[TG] [TG11] 3.11.42 update and no heading error
05-29-20, 02:20 AM
Post: #4
Tom - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 1,067
Joined: Nov 2017
Reputation: 7
RE: [TG11] 3.11.42 update and no heading error
Hello Wdeertz,

We know that you can get the alarm with heading data through a convertor because the Seatalk1 heading data rate is just 2Hz, but I would not expect it with heading from the AR200. I assume this was through a manual Data Source selection: do you still get the same with the autopilot (temporarily) disconnected?

Thanks,
Tom
Raymarine since 1999.
Interests: Diagnosis of problems in sonar/fishfinders, NMEA2000, ethernet comms, autopilots, thermal cameras
Location: Sydney, Australia.

Please don't PM me asking for direct support, please ask a public question instead so that others can see the question and answer. Forum posts will always be answered before PM requests.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [TG11] 3.11.42 update and no heading error - Tom - Raymarine - Moderator - 05-29-20 02:20 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication