[TG] [TG11] 3.11.42 update and no heading error

[Glorydays]

Hi Tom,
I finally got back to the boat and checked. A little background; on my original installation the installer connected my ST8002 auto pilot via a NMEA0183 connection and it worked fine. i thought I could utilize the functionality of the pilot screens by configuring a SeaTalk STNG Converter and so changed to that connection, and subsequently found out that I could not utilize the pilot screens.

So to answer your question. When I checked the heading data source the 183 connection was checked, i manually changed it to the Converter source. I am still getting the "no heading alarm", however, i do have a valid heading.

This issue presented after the software update. Should I do a factory reset?

thanks.

Mike