Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
ST60 Wind Direction No Longer Working
06-15-16, 12:44 PM (This post was last modified: 06-15-16 12:47 PM by Chuck - Raymarine - Moderator.)
Post: #2
RE: ST60 Wind Direction No Longer Working
Welcome to the Raymarine Forum svbloom,

If the wind transducer is connected directly to the transducer terminals of the ST60 Wind Instrument, then the fault may be rooted in the wind transducer and/or the ST60 Wind Instrument itself. It is recommended that the Wind Transducer be tested per the FAQ found here. Should the transducer be determined to be good, then it is recommended that the ST60 Wind Instrument be disconnected from all but the transducer and a source of power. Should the problem persist when isolated from the other equipment, then the ST60 Wind Instrument would be deemed to have failed. As Raymarine can no longer service ST60 Instruments, the ST60 Wind Wind Instrument may be replaced by an i60 Wind Instrument or an iTC-5 Analog Instrument Transducer in conjunction with an i70 Multifunction Instrument Display.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: ST60 Wind Direction No Longer Working - Chuck - Raymarine - Moderator - 06-15-16 12:44 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)