[TG] [TG11] Axiom 12 can't find Radome
|
06-01-20, 01:18 PM
Post: #3
|
|||
|
|||
RE: [TG11] Axiom 12 can't find Radome
I'm missing something.
This is a quote that Chuck wrote: "Should the vessel be equipped with a bonding plate and bonding cable, then the drain leads from marine electronics should be connected to the vessel's bonding cable." My boat has a cable that connects all of the through-hulls to each other and is also attached to the engine block. I attached my drain to the same point this cable is attached to the block. Should my bonding cable not be connected to the engine block? I ran a 10 Ga. wire directly from the battery to the Radar cable (with a fuse in line just in case) just to test the power theory, as I also suspected a low power situation. That did not help. I have not disconnected the drain line but will try that. |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
[TG11] Axiom 12 can't find Radome - Vettepro - 05-26-20, 10:03 AM
RE: [TG11] Axiom 12 can't find Radome - Tom - Raymarine - Moderator - 06-01-20, 02:21 AM
RE: [TG11] Axiom 12 can't find Radome - Vettepro - 06-01-20 01:18 PM
RE: [TG11] Axiom 12 can't find Radome - Tom - Raymarine - Moderator - 06-01-20, 08:08 PM
|
User(s) browsing this thread: 1 Guest(s)