S1000 not being seen by S100
|
07-14-16, 03:43 PM
Post: #2
|
|||
|
|||
RE: S1000 not being seen by S100
Hello Seacom,
After the system is powered, check for the green led on the S1000. If the green led is present, then attempt to de-reg and re-reg the S100 controller by performing the following steps. Press and hold "Standby" until there are words on the screen. Release Press and hold "Mode" until software [censored] on screen. Release Momentarily press (like a door bell) "Mode" until register information appears on screen. De-reg the S100 and then re-reg the S100 following the on screen information. |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
S1000 not being seen by S100 - Seacom - 07-04-16, 04:59 PM
RE: S1000 not being seen by S100 - Mark - Raymarine - Moderator - 07-14-16 03:43 PM
|
User(s) browsing this thread: 1 Guest(s)