The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Radar v / Radar Wiring question

Thread Closed 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Radar Wiring question
07-07-16, 05:43 PM
Post: #1
Vettepro Offline
Junior Member
**
 		Posts: 24
Joined: May 2016
Reputation: 0
Radar Wiring question
I have an A98 MFD. The A98 is on a switch. I added the EV100 autopilot and ran 8 gauge wire directly to the main battery switch for power. Ground and drain go directly to the battery. Power is only interrupted when the batteries are turned off.
Now I've added the RD424HD radar. Can I just tie into the existing 8 gauge wiring I just mentioned, rather than run new ones ?
This would have power to the radome full time. (except when the batteries are turned off) I'm assuming the MFD is what will actually turn the radar (as well as the autopilot) on and off? There is no need to have switched power to the hot lead? ( it is fused but not switched)
Thanks
Find all posts by this user
Thread Closed 


Messages In This Thread
Radar Wiring question - Vettepro - 07-07-16 05:43 PM
RE: Radar Wiring question - Vettepro - 07-09-16, 08:47 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication