EV-100 / C120 classic setup
|
07-12-16, 03:48 PM
Post: #2
|
|||
|
|||
RE: EV-100 / C120 classic setup
Hello Solomon,
The SeaTalkNg converter (E22158) is designed to convert SeaTalkNg data into the old SeaTalk1 protocol. Therefore the three prong cable coming out of the converter needs to be plugged into the 3 prong connector labeled "SeaTalk" on the back of the C80, not into the five prong "Seatalk2" connector. If you have "something" already plugged into the 3 prong connector labeled "SeaTalk" port then you need an additional junction block (D244) where you would connect both the 3 prong cable from the converter, the original cable plugged into the C80 displays "SeaTalk" port and then another "SeaTalk" cable (D284) that would run from the D244 to the "SeaTalk" port on the back of the C80. In this scenario the 5 prong "Seatalk2" connector is not utilized. |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
EV-100 / C120 classic setup - solomon - 07-10-16, 08:44 AM
RE: EV-100 / C120 classic setup - Mark - Raymarine - Moderator - 07-12-16 03:48 PM
RE: EV-100 / C120 classic setup - solomon - 07-14-16, 05:37 PM
RE: EV-100 / C120 classic setup - Chuck - Raymarine - Moderator - 07-18-16, 10:33 AM
|
User(s) browsing this thread: 1 Guest(s)