Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Wind transducer gone bad?
07-19-16, 09:25 AM
Post: #2
RE: Another wind transducer gone bad?
Welcome to the Raymarine Forum Paul,

It is recommended that the wind transducer be disconnected from the masthead block and that the entire wind transducer cable assembly from the iTC-5 to the masthead block be tested for continuity and short circuits. Should any shorts be detected, then the masthead block and cable will need to be replaced or the shorted transducer cable segment will need to be removed and spliced. Should no shorts of broken leads be detected, then the wind transducer should be sent to Raymarine’s Product Repair Center to be bench tested / serviced.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Wind transducer gone bad? - PaulM - 07-18-16, 02:39 PM
RE: Another wind transducer gone bad? - Chuck - Raymarine - Moderator - 07-19-16 09:25 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)