Post Reply 
 
Thread Rating:
  • 1 Vote(s) - 2 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Fusion RA 205 interfacing to multiple MFDs connected via HS5
02-27-17, 05:41 PM
Post: #10
RE: Fusion RA 205 interfacing to multiple MFDs connected via HS5
Ovi,

The diagram does not appear correct and also appears to be missing items (i.e. the model autopilot course computer installed, how the SeaTalk to SeaTalkng Converter is being powered (the SeaTalk to SeaTalkng Converter should not be powered by the autopilot course computer). Additionally, the following items should be added:
- the SeaTalkng 5-Way Junction Block must be connected to the SeaTalk to SeaTalkng Converter by an appropriate length of SeaTalkng Backbone Cable
- the SeaTalkng backbone should be properly terminated (i.e. one SeaTalkng Termination plug in the remaining blue backbone socket of the SeaTalkng 5-Way Connector and SeaTalk to SeaTalkng Converter
- a SeaTalkng Power Cable must be interfaced to one of the spur sockets within the backbone created by the SeaTalkng 5-Way Connector and SeaTalk to SeaTalkng Converter
- the unpowered Fusion spur cable called out within the previously referenced FAQ must be used along with the Fusion RA 205.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Fusion RA 205 interfacing to multiple MFDs connected via HS5 - Chuck - Raymarine - Moderator - 02-27-17 05:41 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)