The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error





Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
S100 Did I buy the wrong model?
09-16-16, 12:08 PM
Post: #1
S100 Did I buy the wrong model?
Just bought an S100. It has the Sea Talk 3 pin plug on the base station. My current instruments are all Sea Talk ng products. Connectors are not compatable. A literature search shows a converter kit E22158 but reading the literature leaves me unsure if this will work. My S100 is E15024. My existing next gen gear is i50 E70059 depth, i50 E70058 speed, i60 E70061 analogue wind, c95 E70011 MFD, P70 E22166 autopilot controller, M81130 linear drive, E70096 EV1 evolution sensor, and E70099 ACU 200. All share the same backbone and 3 A06049 5 way connectors tie it all together. There is one blank plug on the 5 way connector that is wired to the EV1 and buss power supply and ties the other 2 A06049 connectors together so it is in the "middle" of the backbone. Wpould my S100 work if i buy the converter kit E22158 and plug it into the blank plug, then wire the S100's base station to the kit?
Regards
Rick Parish
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
S100 Did I buy the wrong model? - seabreeze - 09-16-16 12:08 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)