MyBB Internal: One or more warnings occured. Please contact your administrator for assistance.
Vektor setting and laylines


Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Vektor setting and laylines
10-24-16, 09:12 AM
Post: #1
Vektor setting and laylines
HI i have problems, getting it right even if i chose the setting calculate tide
the vind direction isn't right the calculation is not calculated on COG but HDT
se the 2 picture below on starboard it should subtract the drift and on port added , in the advance setting you can set cal drift but nothing happens, but it have effect on the lay line set up so it doing it right , but in the layline setup there is also a setting for cal drift but it not working ??

kindregard
Peter Wraa


Attached File(s) Thumbnail(s)
       
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Vektor setting and laylines - wraa - 10-24-16 09:12 AM
RE: Vektor setting and laylines - wraa - 11-03-16, 06:50 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)