Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Seatalk2 to STng
12-08-17, 12:18 PM
Post: #13
RE: Seatalk2 to STng
Ok I think I understand this. I tried attaching the i50 installation and operating instructions 81341-4-ENG, but it wouldn't let me. Page 30 (sec 4.7) shows a seatalk network. Here the devices will bridge the data between the devices. It appears that even though STNG connections are being used, only ST data are being transferred, so even though it looks like instruments 2,3 &4 are talking via STNG, they are in fact talking via ST. Is that the case? If that is the case then no device which requires STNG (eg ST290 speed or p70) will operate on this network. Note that while the p70 does not "require", STNG, you can't calibrate the autopilot without it, so it kind of does require it.
Thanks
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Seatalk2 to STng - Kevin - 12-12-16, 03:03 PM
RE: Seatalk2 to STng - Kevin - 06-26-17, 01:19 PM
RE: Seatalk2 to STng - Kevin - 06-27-17, 07:20 AM
RE: Seatalk2 to STng - Kevin - 06-28-17, 06:32 AM
RE: Seatalk2 to STng - tgsail1 - 12-01-17, 10:22 AM
[CA] RE: Seatalk2 to STng - tgsail1 - 12-04-17, 10:58 PM
RE: Seatalk2 to STng - tgsail1 - 12-08-17 12:18 PM
RE: Seatalk2 to STng - tgsail1 - 12-23-17, 10:28 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)