Cam220ip

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

Cam220ip

12-19-16, 12:14 PM

Post: #1

khelberg Offline

Junior Member

Posts: 6
Joined: Dec 2016
Reputation: 0

Cam220ip

I installed a cam220ip and am trying to connect to an ES78 MFD. I applied power via the two power wires. The red led shows there is power to the unit. I connected to MFD using an A62360 cable into the network port on the back of the MFD. But the MFD does not display the camera.

Any clue as to what is wrong. Can the camera be routed to the MFD thru the SeaTalk net? if so what is the cable I need.

« Next Oldest | Next Newest »

Messages In This Thread

Cam220ip - khelberg - 12-19-16 12:14 PM

RE: Cam220ip - Chuck - Raymarine - Moderator - 12-19-16, 04:49 PM

RE: Cam220ip - khelberg - 12-20-16, 06:30 PM

RE: Cam220ip - Chuck - Raymarine - Moderator - 12-21-16, 10:08 AM

RE: Cam220ip - khelberg - 12-22-16, 10:42 AM

RE: Cam220ip - Chuck - Raymarine - Moderator - 12-22-16, 11:03 AM

RE: Cam220ip - khelberg - 12-29-16, 07:25 PM

RE: Cam220ip - Chuck - Raymarine - Moderator - 12-30-16, 10:49 AM

RE: Cam220ip - khelberg - 12-31-16, 12:46 PM

RE: Cam220ip - Chuck - Raymarine - Moderator - 01-03-17, 04:00 PM

User(s) browsing this thread: 1 Guest(s)