Raymarine forum / Raymarine Forums / Multifunction Displays v / Transducer selection

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Transducer selection
12-29-16, 12:08 PM
Post: #11
DFMott Offline
Member
***
 		Posts: 60
Joined: Dec 2016
Reputation: 0
RE: Transducer selection
I received and installed the new cable and the set-up menu now shows the B164 as a choice. The cable only has 6 pins in the 9 pin connector so it connected with no modification. I can't believe someone would jury-rig a cable when doing the original install.

However, I am still not sure that everything is working ok. When I go into set-up and search for external transducers it still doesn't find anything. Should it display the B164 and its serial number?
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Transducer selection - DFMott - 12-20-16, 01:51 PM
RE: Transducer selection - DFMott - 12-21-16, 01:15 AM
RE: Transducer selection - DFMott - 12-21-16, 01:39 PM
RE: Transducer selection - DFMott - 12-22-16, 12:41 AM
RE: Transducer selection - DFMott - 12-23-16, 01:12 AM
RE: Transducer selection - DFMott - 12-29-16 12:08 PM
RE: Transducer selection - DFMott - 12-30-16, 02:52 PM
RE: Transducer selection - DFMott - 01-01-17, 11:53 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication