The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Multifunction Displays v / E127 MFD Shows My Location on Land

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
E127 MFD Shows My Location on Land
12-28-16, 10:40 AM
Post: #1
N1ml Offline
Junior Member
**
 		Posts: 7
Joined: Feb 2016
Reputation: 0
E127 MFD Shows My Location on Land
I was out boating Monday and noticed that the MFD indicated that my position was on land. I have dual E127 displays. Usually I have it set up as heads up, with my current position shown as a small boat with a cross superimposed on it. All of a sudden the boat and cross got separated. I powered down and powered up. All was OK and then I got a couple of beeps and a popup came on. I tried to cancel the popup informing me of a waypoint, it cleared and then the problem with my position came up again. My software is V17-17.45. I noted online that I am one revision out of date. This problem has happened before, but then it went away. It came back several times. I am also running Navionics mapping software.
Is there something I should check?
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
E127 MFD Shows My Location on Land - N1ml - 12-28-16 10:40 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication