The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.3.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error





Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
A128 lake water temp
02-02-17, 09:35 PM
Post: #1
A128 lake water temp
I have two A series MFDs on my Ranger. Always been a Lowrance guy, but the Raymarine MFDs were installed in the boat when I bought it. After a small learning curve, I actually prefer the MFDs over the Lowrance units on my last boat. I have an A127 at the bow with a CPT 100 Transducer on the TM, which provides me with both 2D & Down Vision Sonar. The transducer also provides me with water temp.
At the console, I have an A128 with a shoot through transducer in the bilge for 2D Sonar and a CP200 Module for Side Vision, with the transducer mounted to the jack plate. The CP200 transducer does not provide a water temperature reading and I need it at the console, while running the big motor. How do I add water temp, without adding the CP100 module, which has the water temp sensor??
I can't add another transducer to the unit, so I'm looking for some advise.
Thanks in advance,
r/
Steve
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
A128 lake water temp - Natch - 02-02-17 09:35 PM
RE: A128 lake water temp - Natch - 02-03-17, 01:10 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)