Raymarine forum / Raymarine Forums / Autopilots v / [CA] S100 Remote Control With EV-200

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] S100 Remote Control With EV-200
04-14-18, 09:42 PM (This post was last modified: 04-16-18 01:48 PM by Chuck - Raymarine - Moderator.)
Post: #11
Alaskan Sea-Duction Offline
Junior Member
**
 		Posts: 45
Joined: Oct 2016
Reputation: 0
RE: [CA] S100 Remote Control With EV-200
I am installing a S100 Remote to my new EV 400 Auto pilot system. I also have a new eS170 MFD.

I have installed the base station. I have routed the base station plug to a D244 3-pin block. Then from the middle connector on the block I have connected an A06047 to the SeaTalk (white) network. When I power the S100 up it searches for the network then I get "No Pilot" and when I push the standby button it says " Setup Unavailable." The antenna display on the unit reads 3 bars.

eS174 has Lighthouse II as I am running it with a C97.

So what am I doing wrong?

Thanks

Tom
1988 Camargue Yacht Fisher
Tom and Kay
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA] S100 Remote Control With EV-200 - Alaskan Sea-Duction - 04-14-18 09:42 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication