Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Issue when following a route on my E70275-NAG
05-01-17, 03:49 PM
Post: #2
RE: Issue when following a route on my E70275-NAG
Welcome to the Raymarine Forum John,

Per our discussion this morning, the issue reported is associated with a large radius for the Waypoint Arrival Circle (HOME->SET-UP->ALARMS->SAFETY ALARMS->WAYPOINT ARRIVAL). The default setting for Arrival Circle radius is 0.1nm (approx. 600'). This value may be reduced to as little as 0.01nm (approximately 60'). In this specific case, the vessel was located within the arrival circle of the route's first two waypoints, causing the associated notifications and for navigation to then resume at the route's third waypoint. When the MFD or autopilot control head is used to acknowledge that it is safe to steer to the next waypoint of the route, then the boat will immediately execute steering changes. However, should it be desired that the vessel initiate the turn in much closer proximity to waypoint, then the waypoint arrival circle setting will need to be decreased accordingly.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Issue when following a route on my E70275-NAG - Chuck - Raymarine - Moderator - 05-01-17 03:49 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)