The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error





Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Open array " scanner not responding "
05-02-17, 10:48 AM
Post: #1
Open array " scanner not responding "
HI,
I have a M92654-S 4kw open array radar. I receive a warning alert on my display
"Scanner not responding"
I verified good 12 volt power at the radar pedestal array unit. (12.38 volts)
I ran an ohms test with results below.

Video pins 1&2 white and black wires reading 45.9 kohms

Azimuth pins 12&13 violet/purple and gray reading 9.38 kohms

Trigger pins 4&7 orange and yellow reading 9.39 kohms

Data I/O pins 6&10 green and blue reading 182.8 to 183.2 ohms

I verified the readings with 2 multi meters. Are these considered good connections?
I measured readings at plug display cable end and at scanner connection inside pedestal.
Is there something else I should look for to remove the display warning?
Thanks in advance,
Dan
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Open array " scanner not responding " - Dan W - 05-02-17 10:48 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)