AIS650 Does Not Trasmit

[Chuck - Raymarine - Moderator]

Welcome to the Raymarine Forum Elba,

Please click here to view a FAQ addressing this subject.

The AIS650's Status LED sequence appears to indicate proper operation of the product. Should the Status LED remain green, then the AIS650 believes that
- a MMSI has been programmed into the AIS650,
- the AIS650's internal GPS receiver has acquired a GPS position FIX via the connected passive GPS antenna
- the AIS650 has not been configured to silent mode

The ProAIS2 software supplied with the AIS650 and found here may be installed on a computer. After doing so, the AIS650's USB port may be plugged into a computer to then permit the ProAIS2 software to interface with the AIS650. In doing so, the owner or installer may determine the version of software installed within the AIS650 and determine the antenna VSWR detected by the AIS650. Should the antenna VSWR be determined to be too high, then the AIS650 will transmit alarm messages to the MFD. It would not be typically possible to detect lightning damage without inspecting the circuitry of the AIS650.