Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Switch panel not attached on E125
03-11-16, 09:43 AM
Post: #2
RE: Switch panel not attached on E125
Welcome to the Raymarine Forum HemiGTX,

Reset easy, as there's nothing wrong with your key mats. The key mats of the c/e-Series MFDs are designed to be held in place by the MFD's trim ring. When installing the key may, the tabs on the key mat's left side are designed to fit into a groove within the left side of the black ring surrounding the MFD's screen. After properly positioning the key mat, the MFD's trim ring will then be rotated into the correct orientation (recess for microSD memory card reader in the lower right hand corner), and then be snapped into place.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Switch panel not attached on E125 - Chuck - Raymarine - Moderator - 03-11-16 09:43 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)