The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error





Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Yamaha Gateway to Axiom
07-01-17, 12:24 AM
Post: #1
Yamaha Gateway to Axiom
Read through the info on the Engine data interfacing. I am still a bit unclear. So, I have the connections to my Yamaha 300 HP V8 connected through the Yamaha gateway as shown in the attached illustration. I have the data going into my properly connected and terminated NMEA 2K Network. And the NMEA 2K Net is interfaced to my Axiom 9 Master. Only Data showing on my Axiom 9 is RPM and Trim. All other NMEA data seems to be showing up (Haven't tested the AIS yet).

This is the Yamaha Part that I was told I needed to interface the data with my Chartplotter.

Yamaha 6Y9-8A2D0-40 NMEA 2000 Gateway

~R~
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Yamaha Gateway to Axiom - Randar - 07-01-17 12:24 AM

Forum Jump:


User(s) browsing this thread: 2 Guest(s)