ITC-5 voltage
|
07-17-17, 01:37 PM
Post: #1
|
|||
|
|||
ITC-5 voltage
I have wind, speed and depth transducers connected to ITC-5 converter, connected to I70 instruments and ES plotter. Recently Wind direction indicator stopped reading wind direction change. Indicator on instrument only changes slightly from "stuck "position. I did test of wind transducer and read only 6 volts between red and ground. I supplied 8 volts from separate power supply and wind instrument preformed normally. The 6 volts was read off of the ITC-5 at wind power spade connector. All other instruments are working fine. I read 8 volts at the speed power connection and wondered if I could safely draw wind power from the speed power connection until I was in a position to replace or repair the ITC-5 converter. If indeed thats the problem.
Thank you for in advance for your help. Randy |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
ITC-5 voltage - Randy - 07-17-17 01:37 PM
RE: ITC-5 voltage - Chuck - Raymarine - Moderator - 07-26-17, 03:44 PM
RE: ITC-5 voltage - Randy - 07-27-17, 07:41 AM
RE: ITC-5 voltage - Chuck - Raymarine - Moderator - 07-27-17, 08:54 AM
|
User(s) browsing this thread: 1 Guest(s)