The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Autopilots v / ST 6000 auto helm

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
ST 6000 auto helm
08-22-17, 03:50 PM
Post: #1
Robert Powell Offline
Junior Member
**
 		Posts: 3
Joined: Aug 2017
Reputation: 0
ST 6000 auto helm
RE: Mechanical Installation of drive unit
I recently had my ST 6000 unit reworked at Raymarine and am now re-installing it. Reviewing the manual I find it hard to believe but there are only installation instructions for the electrical connections and the control unit and absolutely nothing about the mechanical installation of the drive unit.
I have replaced the drive unit on the pivot rod and have extended the drive arm to its connection point on the rudder yoke. However, there is a loose nut just exiting the large part of the drive arm which looks like it should be tightened to the end of that part of the drive arm. However, what position should the arm be when that nut is tightened?
Your manual does not address this at all. Please help
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
ST 6000 auto helm - Robert Powell - 08-22-17 03:50 PM
RE: ST 6000 auto helm - Robert Powell - 08-24-17, 02:28 PM
RE: ST 6000 auto helm - Robert Powell - 08-25-17, 10:11 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication