Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
ST 2000 not working and not
09-29-17, 09:30 AM
Post: #2
RE: ST 2000 not working and not
Welcome to the Raymarine Forum Skipron,

The ST2000+ is not designed to function when its power connections are reversed. Per Section 4.3 - Cabling and Socket Installation of the ST1000+ / ST2000+Tiller Pilots Owner's Handbook, pin 1 should be connected to a +12VDC circuit and pin 2 should be connected to -12VDC. Should you find that the tiller pilot has been incorrectly installed with respect to its power connections, it is recommended that these connections be connected to reflect the information found within Section 4.3 and that the tiller pilot then be tested.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
ST 2000 not working and not - skipron - 09-28-17, 09:14 AM
RE: ST 2000 not working and not - Chuck - Raymarine - Moderator - 09-29-17 09:30 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)