Digital Radom reboots but only when gain is in offshore mode
|
10-17-17, 08:35 AM
Post: #4
|
|||
|
|||
RE: Digital Radom reboots but only when gain is in offshore mode
Jon,
Digital Radar Cable failures are a rare occurrence unless the cable has been modified. The communications protocol between the MFD and Digital/HD Digital Radomes is Ethernet and may be verified using common Ethernet testers or by performing a test bypass of the Ethernet portion of the cable. This would be accomplished by obtaining an appropriate length of Ethernet Cable an then connecting the cable between the SeaTalkhs Network Switch and the female RJ45 socket inside of the radome. The most common failure points are: - power - communications ... as the system feature a SeaTalkhs Network Switch, it is recommended that the switch's female sockets for signs of corrosion and to then replace the switch with a HS5 RayNet Network Switch (cables will need to be adapted) should corrosion be found. |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
Digital Radom reboots but only when gain is in offshore mode - jscname - 10-14-17, 07:25 PM
RE: Digital Radom reboots but only when gain is in offshore mode - Chuck - Raymarine - Moderator - 10-16-17, 04:09 PM
RE: Digital Radom reboots but only when gain is in offshore mode - jscname - 10-16-17, 08:56 PM
RE: Digital Radom reboots but only when gain is in offshore mode - Chuck - Raymarine - Moderator - 10-17-17 08:35 AM
|
User(s) browsing this thread: 1 Guest(s)