Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] E120 data feed, move from Seatalk 1 to Seatalk ng
02-02-18, 01:33 PM
Post: #10
RE: E120 data feed, move from Seatalk 1 to Seatalk ng
Hi Chuck,

One follow-up observation. After having completed the install per this thread, I've noted that the E120's do not recognize the S3G autopilot as being available to feed course data and reflect the status of the autopilot. Any idea why?

The plotters are enabled for pilot control via the system integration menu, so that seems ok.

Perhaps a clue: while rewiring the Seatalk 1 devices, I found that both Seatalk 1 ports on the S3G were connected to the bus, I elected to just have one connected to the Seatalk bus. Could that be a factor? All functions from the ST8000 and wireless pilot remote, all on the Seatalk 1 bus, work correctly. So it seems the Seatalk 1 to NG bridge is not passing status and data back and forth between the plotters and the pilot.

Thanks in advance for the help.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: E120 data feed, move from Seatalk 1 to Seatalk ng - lotharjt - 02-02-18 01:33 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)