Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] i50 Tri-Data: Setting race timer
12-05-17, 04:47 PM
Post: #2
RE: [CA] i50 Tri-Data: Setting race timer
Welcome to the Raymarine Forum mlaver,

This problem is generally encountered when the Trip and Reset buttons are not pressed at the same moment or when these buttons have been held pressed for too long. When TIMER is displayed, a momentary press & release of both the Trip and Reset buttons simultaneously is used to both cause the i50 Tridata to enter a mode where the countdown timer may then be adjusted. This is signaled to the operator by the flashing countdown timer value. The Trip button may be used to decrease the value of the timer, while the Reset button may be used to increase the value of the timer. When configured to the desired value, then once again, a momentary press & release of both the Trip and Reset buttons simultaneously will cause the i50 Tridata to exit this mode ... signaled by the Timer value no longer flashing.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA] i50 Tri-Data: Setting race timer - Chuck - Raymarine - Moderator - 12-05-17 04:47 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)