Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] Issues w Fishfinder and Axiom MFD
12-07-17, 10:13 AM
Post: #4
RE: [CA] Issues w Fishfinder and Axiom MFD
Moonzy,

Should you have commanded the CP370 to be reset, then it would have lost its transducer setting. As indicated, the currently available software for the Axiom MFDs would have then prevented a new transducer to be selected for the CP370. Per my initial response, disconnecting the transducer from a CP370 while it is powered ON may result in damage to the CP370 and/or the transducer. Should you not have included the information concerning the model of transducer installed onboard your boat within the note packaged with your CP370, then it would be recommended that the Repair Center be contacted after your CP370 has been received to provide this information to permit the CP370 to be configured for use with your model of transducer. That said, it is quite possible that the LightHouse 3.3.x software for the Axiom / Axiom Pro MFD may be released prior to you receiving your updated CP370 from the Repair Center.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA] Issues w Fishfinder and Axiom MFD - Chuck - Raymarine - Moderator - 12-07-17 10:13 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)