Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] Wind vane showing no wind speed
12-27-17, 02:37 PM (This post was last modified: 12-28-17 02:20 PM by Chuck - Raymarine - Moderator.)
Post: #2
RE: [CA] Wind vane showing no wind speed
Welcome to the Raymarine Forum astroebel,

Please click here to view a FAQ addressing this subject. The reported fault may be indicative a failure within the transducer or within the instrument (or iTC-5/pod). Whereas the measured voltage for the leads associated with speed was within the voltage range specified (please note that you should also observe some fluctuation in the voltage), then the fault would appear to be rooted in the instrument to which the wind transducer has been interfaced or in the transducer's connections to the instrument. Accordingly, it is recommended that the connections to the instrument be inspected and if found to be sound, that the instrument (or iTC-5/pod) be sent to Raymarine’s Product Repair Center to be bench checked / serviced.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA] Wind vane showing no wind speed - Chuck - Raymarine - Moderator - 12-27-17 02:37 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)