The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error





Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] Interfacing eS-128 to Existing NMEA 2K temp sensor
01-10-18, 04:20 PM (This post was last modified: 01-11-18 11:23 AM by Chuck - Raymarine - Moderator.)
Post: #1
[CA] Interfacing eS-128 to Existing NMEA 2K temp sensor
Hi , How do I display the temperature of an existing NMEA 2k Temp sensor on my eS-128 MFD. This happens to be an ambient air temp. I had an existing NMEA 2K network that is now connected to the eS-128. I see the temp sensor in the NMEA 2k diagnostics . I haven't been able to figure out how to display the temp on a either a chart as an overlay or elsewhere.
Thanks
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA] Interfacing eS-128 to Existing NMEA 2K temp sensor - trr - 01-10-18 04:20 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)