Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] CP100 and multiple transducers?
01-22-18, 03:23 PM (This post was last modified: 01-22-18 04:03 PM by Chuck - Raymarine - Moderator.)
Post: #4
RE: [CA] CP100 and multiple transducers?
Steve,

It appears that you have a misunderstanding about how the P66 is presently and may be interfaced to your system. Only devices having an Ethernet communications interface may be interfaced to an Ethernet switch such as the HS5 RayNet Network Switch. The P66 transducer features an analog interface and may only be interfaced to the fishfinder Transducer socket of one of the e7D MFDs. Should a CPT-100 be installed onboard, then it will be interfaced to the Transducer socket of the CP100. The Ethernet Network socket of each MFD and the CP100 would then be interfaced to a powered HS5 RayNet Network Switch via an appropriate length of RayNet (F) to RayNet (F) Cable. When so installed, you may select from 50kHz sonar, 200kHz sonar, CHIRP sonar, or DownVision sonar. Your system will also continue to have access to speed and water temperature data. As the system features only one speed sensing transducer, no source selection need be performed for the Speed data source.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA] CP100 and multiple transducers? - Chuck - Raymarine - Moderator - 01-22-18 03:23 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)