Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Axiom pro 9 Chart problem
05-31-18, 11:58 AM (This post was last modified: 05-31-18 12:00 PM by Chuck - Raymarine - Moderator.)
Post: #4
RE: [CA11] Axiom pro 9 Chart problem
Bob,

While depth contours will be visible when viewing the Navionics Nautical Charts, the depth contour interval will be significantly lower when viewing Navionics SonarCharts, where a significantly greater number of depth contours will be visible. To maximize the number of depth contours visible when viewing Navionics Nautical Charts, the following settings should be used:
- MENU->LAYERS->CHART DETAIL->MEDIUM/HIGH
- MENU->LAYERS->EASY VIEW->OFF
- MENU->SETTINGS->DEPTHS->SHOW CONTOURS->ALL

Should this not permit sufficient depth contours to be shown within the displayed Navionics Nautical Charts, then it would be recommended that you consider displaying two Chart application panes within the page being viewed. One Chart application pane would be configured to display Navionics Nautical Charts (MENU->DETAILED) and the other Chart application pane would be configured to display Navionics SonarCharts (MENU->FISHING).
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA11] Axiom pro 9 Chart problem - Chuck - Raymarine - Moderator - 05-31-18 11:58 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)