Thread Closed 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
(DG) Installing new Raymarine products
03-07-18, 07:21 AM (This post was last modified: 03-07-18 07:47 AM by Derek - Raymarine - Moderator.)
Post: #2
RE: (DG) Installing new Raymarine products
Hi Kurt Warneke
Thank you for your enquiry below,

The AXIOM 9 PRO is quite a different shape to the C80 and so we do not have an adapter plate available. The Plate used for the AXIOM instead of the AXIOM PRO could possibly be adapted, but it would be tricky and we would suggest it is better to fabricate your own plate instead.

The diagram that you attached looks good, with the exception of the STng cabling and connections. See the connection panel below . . .

[Image: attachment.php?aid=1666]

There is only one NMEA2000 (fully compatible with STng) connection. Your diagram shows the STng spur for the Evolution pilot connected to one of the RayNet network connections, this is incorrect, RayNet is used to connect additional displays, radar and sonar modules and carries video and data, whereas NMEA2000 only carries nav data.
The Spur cable you have shown connecting the AXIOM 9 PRO to the T piece should be removed and instead you should connect the backbone to a new 5 way connector block (instead of the T piece) - this new 5 way block will have the terminator in one end and then connect the p70Rs to one of the spurs on the 5 way block and the AXIOM PRO 9 to another of the spur connectors.

regards


Attached File(s) Thumbnail(s)
   
Find all posts by this user
Thread Closed 


Messages In This Thread
RE: (DG) Installing new Raymarine products - Derek - Raymarine - Moderator - 03-07-18 07:21 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)