The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error





Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] Camera settings
03-19-18, 10:10 AM (This post was last modified: 03-19-18 10:46 AM by Chuck - Raymarine - Moderator.)
Post: #1
[CA] Camera settings
Per your forum, I have installed Axis encoders in order to use my existing Raymarine analog cameras with my new Axiom MFDs. I have the Axis M7011s connected to a Netgear PoE switch and the switch is wired to the Raynet network switch. Everything works fine and I can view the cameras on all 5 Axiom units. However, when in the camera settings, under the "image" heading there are no items to chose from like mirror image. Even when I tested a Raymarine IP camera, the only setting under "image" was brightness. Are these settings dependent on the cameras or will the settings be coming in a future software update?

Thank you,
Marc
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA] Camera settings - MSEPA - 03-19-18 10:10 AM
RE: [CA] Camera settings - MSEPA - 03-19-18, 12:20 PM
RE: [CA] Camera settings - MSEPA - 03-19-18, 04:24 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)