[CA] Axion screen flashing and humming

[Oregoncme]

I decided to check the Raynet cable interface. Even though data was flowing, the screen would not sync correctly. The problem was identified by running a Raynet cable over floor and up the ladder in hopes that it may be the cause of the instability. Once the new cable was replaced, the screen locked on and all was good! Now to figure out why. Upon close inspection of the bad cable, it seemed that a VERY tight turn of the cable pulled through an equally tight pipe, put a mean bend a creased the cable to the point a few wires were damaged inside the jacket (that showed a tear).

Moral of the story, the Axioms work fabulously, when the cables are good.
Don't have helpers "pull cable" without telling them if it seems too tight, stop pulling.